University of Wisconsin resets corn and soybean nutrient rates
UW's updated A2809 guidelines lift P and K soil test ranges for corn and soybeans, redrawing the brackets that set fertilizer rates on Wisconsin farms.
- Entered
- Plot
- 1.6 ha
- Record
- 623 words
- Walk-through
- 3 min
DrillSprayHarvestPlanning window

Agronomist’s notes
- University of Wisconsin updated corn and soybean nutrient guidelines in Publication A2809 this year
- New ranges use soil and yield data from across Wisconsin collected over the past 20 years
- Corn removes roughly 0.38 lb P2O5 and 0.2 lb K2O per bushel; soybeans remove 0.8 lb P2O5 and 1.26 lb K2O per bushel
- K ranges rose significantly on loamy soils; sandy soils saw no K change
- Alfalfa, wheat, corn silage and vegetable guidelines have not yet been published
Wisconsin farmers now have new phosphorus and potassium rate recommendations for corn and soybeans, after the University of Wisconsin updated its widely used Publication A2809, the Nutrient Application Guidelines for Field, Vegetable, and Fruit Crops in Wisconsin. This year's revision covers the two biggest row crops and draws on soil sample and crop yield data collected across the state over the past 20 years. Corn and wheat growers who haven't revisited their fertility math lately may want to sit down with a calculator and the new tables.
The changes are not cosmetic. Soil test category ranges — the brackets that decide whether your field counts as low, optimum or high — shifted in several directions. Compared with the previous edition:
- Phosphorus ranges increased slightly on both loamy and sandy soils.
- Potassium ranges increased significantly on loamy soils.
- Potassium ranges did not change at all on sandy soils.
Those ranges were built from the correlation between soil test values and relative yield, which is the honest way to do it. More data, new brackets. Simple as that.
What does this change for your fertilizer bill?
Plenty, potentially. The new values apply to what UW calls Demand Level 1 crops: corn grain, soybeans, small grains excluding wheat, and pasture. If your latest soil test sat near a category boundary, the redrawn lines may push your field into a different bracket — and a different application rate.
The logic behind the brackets is straightforward. Test low, and there's a high probability the crop will respond to added nutrients. Test high, and the probability of a response drops — at which point applying more fertilizer is money spent for nothing, with added risk to groundwater and surface water quality as an unwelcome bonus.
One gap worth noting: alfalfa, wheat, corn silage and vegetables sit at higher demand levels, and those updated guidelines have not been published yet. Growers of those crops should keep using the existing tables and watch for the next release.
The arithmetic underneath
The foundation of the rate recommendations is crop removal — the nutrients that leave the field in the harvested grain. UW's removal figures:
- Corn: roughly 0.38 lb of P2O5 and 0.2 lb of K2O per bushel.
- Soybeans: roughly 0.8 lb of P2O5 and 1.26 lb of K2O per bushel.
Multiply those numbers by your yield in bushels per acre and you have your crop removal rate. The UW publishes full equations for calculating application rates for corn and soybeans, plus quick-reference charts in each crop section of the Nutrient Application Guidelines for Wisconsin website, for those who prefer their arithmetic pre-chewed.
How you use the removal number depends on where your soil sits. Optimum is the target zone: the soil supplies enough, and you simply replace what the crop takes. Soils testing low or very low need more than crop removal to build levels up. Soils testing high — or very high, a category used only for potassium — can get by with a portion of the removal rate, drawing levels down gradually toward optimum. And if a soil tests excessively high for P or K, the recommendation is blunt: no phosphorus or potassium fertilizer at all.
Whether you're spreading commercial fertilizer or manure, the underlying balancing act is the same. Too much is costly and raises environmental concerns. Too little costs yield and income. Routine soil sampling remains the only reliable way to know which side of that line you're on.
The University of Wisconsin says it will keep updating guidelines for other crops as research accumulates and data gets evaluated. Farmers wanting the details can find them through the Nutrient Application Guidelines for Wisconsin site or through their local Extension crops and soils educator.
via Farm Progress (Source)
More from Priya Raman
Show full bio
Senior reporter covering technology and product news in production farming and field operations at Arable Wire.
222 articles
Nearby records
- YA 52Guessed fertilizer rates cost farmers real money, soil tests showOctober 30, 2026
- LW 99Side-banded P lifts Saskatchewan field pea yields by 9% on averageOctober 10, 2026
- PU 47New soil test maps microbes that release hidden phosphorusOctober 10, 2026
- DG 77Farmers Test Soil Health in Multi-State Fertilizer Reduction StudySeptember 30, 2026
- FN 69Soil sampling in November and December will shape grass output in 2027November 17, 2026